SUNSETTER AWNING INSTALLATION INSTRUCTIONS
PAGE - 16
APPENDIX D
RESETTING THE REMOTE TRANSMITTER
This procedure describes the actions needed the reset the Remote Transmitter that was supplied with your Motorized Awning. This procedure should only be performed if the Remote Transmitter does not operate the Motorized awning. Please review the steps below to familiarize yourself with the procedure before attempting to complete them.
- Verify that red light on the remote transmitter comes on when you press a button. If the red light does not come on at all or stays on for less than 5 seconds, you will need to replace the battery.
- Press the NEUTRAL (middle) button on the transmitter.
- Unplug the power cord from the wall.
- Insert the wand into the Override crank on the motor and manually open the awning approximately 3 feet but do not completely open.
- Plug the power cord back into the wall and make sure that there is electricity available. Let the awning sit for one minute, undisturbed, without pressing a button on the remote transmitter or unplugging the cord from the wall.
- Unplug the power cord from the wall for 2 seconds.
- Plug the power cord back in for 10 seconds.
- Unplug the power cord for 2 seconds.
- Plug the power cord back in and leave it plugged in.
NOTE: The motor may rotate approximately 2 feet in one direction
and stop.
When the motor stops, press and hold the programming button on the back of the Remote Transmitter (see figure A) for 5 seconds until the motor 'jogs', then release. ( A 'jog' is a short back and forth movement of the motor).
Activate the transmitter by pressing the OPEN and CLOSE buttons at the same time, the motor will jog.
Press the programming button on the back of the Remote Transmitter until the motor jogs and release.
NOTE: If the motor does not operate, you will have to clear the OPEN/CLOSE stop settings on the motor. Please complete ONLY steps 1 thru 5 on page 10 if motor is on the right side, or steps 13 thru 17 on page 11 of Appendix B if your motor is on the left side. After clearing the OPEN/CLOSE stop settings, verify if the transmitter operates the awning. If not, return to this page and repeat the procedure listed above.
Your Remote Transmitter is now reset to operate your Motorized awning. Test the awning for proper operation. If you cleared the OPEN/CLOSE stop setting on the motor, go to Appendix B on page 10 to reset them.
ADD/DELETE A TRANSMITTER
To ADD an additional Remote Transmitter (not the one that was supplied with the awning):
- Press the programming button on the back of the transmitter that was supplied with the awning until the motor 'jogs' - see figure A
- On the back of the additional Remote Transmitter, press the programming button until the motor 'jogs', then release -- see figure A
If you wish to DELETE a transmitter, simply repeat the 2 steps listed above.
Go to Page-15 - PAGE-16 - Go to Page-17