SUNSETTER AWNING INSTALLATION INSTRUCTIONS
PAGE - 15
13. Using a 1/8" drill bit, drill pilot holes approximately 1" deep. Secure the fastener with two #6 x 1-1/2" Phillips screws supplied.
14. Remove the cover from its packaging. Orient the cover so that the sewn hem is facing the house -- see figure 23. Place the first grommet of the protective cover over the first grommet of the protective cover over the first installed fastener. Twist the locking tab on the fastener to secure the grommet in place.
15. Extend the cover to the left and keep it taut. Then mark the center of the next grommet hole centered on the chalk line.
16. Repeat the previous steps for the remaining fasteners.
NOTE: The ends of the protective cover are designed to extend approximately 1-1/2" beyond the overall width of the awning.
OFF SEASON STORAGE ONLY:
Use the supplied bungee cords to secure cover in place - See Figure 23. Slide the loop end of the bungee through the bottom grommets from the outside of the cover, pull the cord over and around the square bar and place over the ball that secures the cord.
Remove bungee cords before using your awning.
Return to step 15 on page 6 to complete the installation of your awning.
Go to Page-14 - PAGE-15 - Go to Page-16