SUNSETTER PATIO LIGHTS INSTALLATION INSTRUCTIONS
WARNING: PLEASE MAKE SURE TO CALL TECHNICAL SUPPORT IF YOU HAVE ANY
QUESTIONS AT ANY POINT. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT
IN PERSONAL INJURY!
PLEASE CALL TOLL FREE 1-800-670-7071 FOR TECHNICAL SUPPORT
PARTS ENCLOSED: Patio Light Assembly, (6) Globes, (6) Hanger Tabs, (6) Fabric attachment button assemblies.
NOTE: THE STEPS BELOW DESCRIBE HOW TO SETUP THE PATIO LIGHTS FOR USE WITH A SUNSETTER AWNING. THE PATIO LIGHTS CAN ALSO BE ATTACHED TO ANY OTHER TYPE OF STRUCTURE USING THE HOOKS AT THE TOP OF EACH GLOBE HOUSING.
PLEASE NOTE THAT LEFT AND RIGHT REFERENCES ARE AS YOU ARE FACING THE HOUSE.
For use WITHOUT a front Screen Room or Weather Breaker Panel installed.
CAUTION: FAILURE TO WEAR SAFETY GLASSES OR TO FOLLOW THE INSTRUCTIONS BELOW CAN RESULT IN PERSONAL INJURY!
STEP 1. Roll the awning out and set it up as you normally would.
STEP 2. Locate the (6) patio light hooks and install hand tight in the top of each light assembly ( see figure 1).
STEP 3. Install a standard light bulb ( 60 watt maximum) in each of the six sockets.
STEP 4. Remove the globes from the plastic bags and screw them onto the socket assemblies
STEP 5. Motorized Awning: Slide the thick part of the six hanger tabs into the unused slot on the front bar ( See Figure 2A).
STEP 6. Attach the hooks on the top of each light assembly into the bottom hole of each hanger tab.
STEP 7. Slide the hangers to adjust the spacing between the SunSetter Patio Lights.
For use WITH a front Screen Room or Weather Breaker Panel installed.
Complete steps 1-4, previously mentioned above.
STEP 5a. Remove the 6 cream color-buttons and attaching pins from the plastic bag.
STEP 6a. With the front panel installed, determine the desired location and spacing of each Patio Light. Measure down 7/16" from the roller bar and insert the attaching pin from the outside of the panel through both layers of theoverlapping fabric ( see figure 3). Install one of the cream-colored buttins over the protruding end of the attaching pin and snap them together. Repeat this process with the remaining 5 button assemblies.
STEP 7a. Place the hook on the top of each Patio Light over the installed button.
CONNECT YOUR SUNSETTER PATIO LIGHTS TO A GROUND FAULT CIRCUIT INTERRUPTER PROTECTED RECEPTACLE ONLY. DO NOT PLACE WITHIN (16) FEET OF A POOL.
IMPORTANT SAFETY INSTRUCTIONS.
This lamp assembly has a polarized plug ( one blade is wider than the other) as a feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. NEVER use with an extension cord unless the plug can be fully inserted. DO NOT ALTER THE PLUG.